I want to deactivate the measurment of unused ports to increase the speed. It can be done in the port configuration, but I have not found a corresponding remote command to do that.
Is there a remote command to remove the "meas" flag for a certain port?
There are two possibilities to deactivate the "Meas" function of a port:
Perform a single port calibration. After the calibration is saved, the "meas" function of all other ports is deactivated. Here is a small SCPI sequence:
CORR:COLL:METH REFL1
CORR:COLL OPEN1
CORR:COLL:SAVE
The sequence performs a normalization with an open standard on port 1. After the last command the "Meas" flag is active for port 1 only.
If you do not want to perform a calibration, you may use that command:
SOUR:GRO:PORT 1
