R&S®ZVA Vector Network Analyzers - Media Center

Level-controlled passive intermodulation (PIM) measurements presented at EuMW 2013

Rohde & Schwarz demonstrated fast and accurate passive intermodulation (PIM) testing of duplex filters at the European Microwave Week 2013 in Nuremberg.

Group delay measurement on devices with embedded LO using option R&S ZVA-K9

This video demonstrates group delay and relative phase measurements on frequency converting devices where access to the LO is limited.

Millimeter wave measurements in one sweep with the R&S®ZVA110 presented at EuMW 2012

Rohde & Schwarz presented the R&S®ZVA110 vector network analyzer at the European Microwave Week 2012 in Amsterdam.

Satellite measurements without LO access presented at EuMW 2013

Rohde & Schwarz presented group delay measurements on converters without LO access at the European Microwave Week 2013 in Nuremberg.

Simplified test setup using R&S®ZVAB-K30 noise figure measurement option

This video demonstrates the simple and straight-forward calibration steps including power calibration of source and receivers, noise figure calibration and system error correction, and the noise figure measurement.

Signal integrity – calibrating a 4-port network analyzer (part 1 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring rise time using a true differential signal (part 2 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring differential impedance vs. distance (part 3 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.

Signal integrity – measuring time domain skew between two lines on a differential transmission (part 4 of 4)

This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.