35 Results
When an additional monitor is connected via the HDMI interface, the touch functionality is lost. How can I get the touch functionality back?
Connection of R&S ScopeSuite to RTO/RTP fails
For some tests a vector network analyzer is required. The Scope Suite software just supports VNAs from R&S to be connected via LAN for automated measurements. Can I use also other VNAs and do the measurement manually?
FAQ - Decoding of SENT protocoll shows CRC errors
When I use the zoom function to look at the rising edge of a rectangle signal, I see ringing which is not real, see screenshot. What is the reason?
I have compared passive and active probes. It seems that the noise with active probes is higher. What is the reason and what can I do to reduce the noise?
Scaling of frequency measurements RTE, RTO, RTP in cycles/min
Is an FSPC license dongle (1310.0002.03) always needed to run the FS-K96 software?
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
R&S Scope Suite - eMMC compliance test fails
When I do RMS measurements and an offset is applied, the result changes. I could not see that effect on other scopes. What is wrong here?
Connection of DUT and Link partner with test fixture RT-ZF2
At startup of RTE/RTO/RTP Windows asks for user and password. How can I get back the autologon function?
RTE/RTO/RTP - Loading a settings file with Labview drivers
I want to export the waveform data of my RTO scope into MATLAB, but the only way I found so far is the screenshot option. Is there another way to use the trace data in my script?
Number of harmonics, RTE, RTO, Power option, FAQ
The SCPI sequence for configuration and data query for the I/Q software interface option K11.
Export of analog and digital channels of the same acquistion
How can I switch between the input impedance of 50 Ohm and 1 MOhm by using SCPI command.
We want to measure the voltage of the main line with our oscilloscope.
Volume Adjustment of the "BEEP"
Accuracy of RMS Measurements
Programming examples for oscilloscopes.
RTO/RTP Setup of Reference Levels for Measurements in Firmware Version 5
R&S Scope Suite - Error communicating with oscilloscope
Which test fixture for MDI mode conversion measurement at 100Base T1 Compliance Test?
RTE/RTO/RTP - export of the history into one file with remote commands
WEB control is not working with the RTO.
When yout set the carrier frequency and the filter bandwidth, you get the warning "CF + BW/2 > DevBW".
I am using the ultra segmentation mode to minimize the blind time. But this is not indicated. Is there a way to calculate it?
The Zoom function does not show any waveform data at specific settings, especially at slower timebases in combination with higher sample rates, High resolution and roll mode with more channels. The problem is gone if a lower sample rate is chosen.
RTE/RTO/RTP: Measurement of the level at a designated frequency in FFT with remote commands.
RTO / RTP Firmware Update from an older Version
Is it possible to do math operations on a measurement? For example measure the frequency but display the result as cycles per minute?
A sinus signal with i.e. 10 V peak-peak, frequency 1 MHz is applied. If I choose a vertical scale which is too small the peaks of the waveform are not displayed as they are out of range. Now I activate the digital filter in the “Vertical” menu à “Channel”. The frequency of the filter is also set to 1 MHz. Now even at very small vertical scales (i.e. 50 mV/div) the waveform is displayed completely, see screenshot. But the amplitude can not be correct. What goes wrong here?
