21 Results
Programming examples for oscilloscopes.
We want to measure the voltage of the main line with our oscilloscope.
RTE/RTO/RTP - Loading a settings file with Labview drivers
Accuracy of RMS Measurements
Number of harmonics, RTE, RTO, Power option, FAQ
At startup of RTE/RTO/RTP Windows asks for user and password. How can I get back the autologon function?
When I do RMS measurements and an offset is applied, the result changes. I could not see that effect on other scopes. What is wrong here?
Scaling of frequency measurements RTE, RTO, RTP in cycles/min
Connection of R&S ScopeSuite to RTO/RTP fails
I have compared passive and active probes. It seems that the noise with active probes is higher. What is the reason and what can I do to reduce the noise?
Volume Adjustment of the "BEEP"
FAQ - Decoding of SENT protocoll shows CRC errors
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
When I use the zoom function to look at the rising edge of a rectangle signal, I see ringing which is not real, see screenshot. What is the reason?
A sinus signal with i.e. 10 V peak-peak, frequency 1 MHz is applied. If I choose a vertical scale which is too small the peaks of the waveform are not displayed as they are out of range. Now I activate the digital filter in the “Vertical” menu à “Channel”. The frequency of the filter is also set to 1 MHz. Now even at very small vertical scales (i.e. 50 mV/div) the waveform is displayed completely, see screenshot. But the amplitude can not be correct. What goes wrong here?
I am using the ultra segmentation mode to minimize the blind time. But this is not indicated. Is there a way to calculate it?
How can I switch between the input impedance of 50 Ohm and 1 MOhm by using SCPI command.
RTE/RTO/RTP: Measurement of the level at a designated frequency in FFT with remote commands.
RTE - How can I get the full record length?
Export of analog and digital channels of the same acquistion
RTE/RTO/RTP - export of the history into one file with remote commands