8237 Results
Next-Generation (3G/4G) Voice Quality Testing with POLQA®
30-May-2012 | AN-No. 1MA202
White PaperThis white paper summarizes significant additional technology components based on LTE, which are included in 3GPP Release 12 specifications.
04-Aug-2015 | AN-No. 1MA252
This white paper provides an introduction to the technology behind WLAN 802.11ad and highlights the test and measurement requirements.
21-Nov-2013 | AN-No. 1MA220
The LTE technology as specified within 3GPP Release 8 was first commercially deployed by end 2009.
09-Jul-2013 | AN-No. 1MA232
LTE Location Based Services (LBS) involve the process of determining where a device is located.
29-May-2015 | AN-No. 1SP05
Joint solutions of R&S® and COMPRION®
This application note describes the eUICC compliance and remote eUICC provisioning test solution based on R&S® CMW500/CMW290 and COMPRION® eUICC Profile Manager software tool.
03-Jun-2020 | AN-No. GFM342
This application note describes a method using the R&S ZVA to measure group delay of mixers and frequency converters with an embedded local oscillator very accurately.
27-Aug-2012 | AN-No. 1EZ60
This Application Note focuses on measurement of harmonics using modern spectrum analyzers. It highlights the source of harmonics before focusing on their measurement using a spectrum analyzer.
02-Mar-2012 | AN-No. 1EF78
This application note shows how to perform LTE terminal block error rate (BLER) and throughput tests under fading conditions with the R&S®CMW500 Protocol Tester and the R&S®AMU200A Fading Simulator.
27-Mar-2012 | AN-No. 1MA177
radiated conformance testing according to TS 38.141-2, Rel. 16
This application note describes all mandatory radiated RF transmitter tests (TS 38.141-2, chapter 6), according to Release 16.
20-Dec-2019 | AN-No. GFM324
LTE Transmission Modes and Beamforming
10-Jul-2015 | AN-No. 1MA186
This document describes the typical measurements performed on mixers and how they can be implemented on the ZVA Vector Network Analyzer with the ZVA-K4 Frequency Conversion option.
06-May-2009 | AN-No. 1EZ58
This application note describes how to integrate R&S®ZVA/ZVB/ZVT vector network analyzers with AWR's electronic design automation (EDA) software. Measured data can be exported using the AWR® TestWave™ tool via GPIB/LAN and verified with simulated data.
01-Jun-2010 | AN-No. 1MA163
This application note describes how to generate and analyze wideband digitally modulated signals in the mm-wave range. Rohde & Schwarz measuring equipment and some 3rd party off-the-shelf accessories are used for both signal generation and analysis.
02-Sep-2014 | AN-No. 1MA217
RMS is one of the most common parameters in test and measurement. Mathematically, it is the quadratic mean of continuously varying values (waveform). R&S RTM-K32 option provides a digital RMS conversion function for a high-bandwidth RMS measurement.
17-Aug-2015
This application note discusses the basics of nonlinearities and describes the nonlinearity measurement using the R&S Value Instruments RF Signal Generator R&S®SMC100A and Spectrum Analyzer R&S®FSC.
20-May-2014 | AN-No. 1MA71
In this whitepaper we introduce the NB-IoT technology with an emphasis on the tight connection to LTE.
08-Aug-2016 | AN-No. 1MA266
This white paper introduces the fundamental theory behind beamforming antennas, calculation methods and measurement results for linear arrays.
15-Sep-2016 | AN-No. 1MA276
Oscilloscopes for education special edition Canada flyer
Save up to 49% on the most popular T&M instrument configurations
Save up to 49% on the most popular T&M instrument configurations
Today's Solutions for Tomorrow's Challenge
Trade-In Promotion. Up to 30% trade in credit for Spectrum and Signal Analyzers.