155 Results
Recall of user's own calibration kits and connectors via remote
Calibration of two channels simultaneously with remote commands
TRL calibration - middle of line or end of line
Is there a way to query the data of all traces at once?
Calculate the mixed-mode S-parameter from an S4P file
4 Port Calibration with a 2 Port automatic calibration kit possible?
What is the function of "Resolve pool link" in the calibration manager?
Most accurate way to measure the length of a cable with a VNA
Reading the magnitude (dB) and phase (degrees) values directly
Loading an S-parameter file from a PC into a memory trace
How can I change the display resolution when I use an external monitor?
Cannot use internal display and external monitor together at the same time.
Which settings should I use for the Transform Time Domain mode?
VNA - do I really need a sliding match for calibration?
Changing the update display rate of a sweep with many sweep points.
Calibrating a vector network analyzer (VNA) with different connectors on each port
Converting the real and imaginary numbers to magnitude in dB and phase in degrees.
R&S®ZVAX-TRM Instrument Security Manual
R&S®ZVAX-TRM User Manual
What is the correct pin layout of the DC inputs on the network analyzer's rear panel?
Sending a remote Control Command internally
I have set my VNA to single sweep mode and switched on averaging with a factor of 10. But when I restart the single sweep, it stops after 1 sweep and the averaging is not done.
Rohde & Schwarz Getting Started for the R&S ZCxxx frequency converters
TDR, TDT, ZVA vector network analyzer This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines
I query the values of a trace using scpi commands. But I get the y-values only. Is there a possibility to get the y-values also (frequency)?
I trigger this single sweep with the RSZVB_Send_Trigger_and_Wait_for_OPC driver, but this driver does not wait for the complete 10 sweeps. If I don't use averaging, this program is works.
How can I switch from remote to local state via remote control?
This application note describes how to configure a Rohde & Schwarz Network Analyzer to make spectral measurements directly on a device under test.
16-Mar-2012 | AN-No. 1EZ62
TDR, TDT, ZVA vector network analyzer This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines.
The R&S®ZVA vector network analyzer in combination with the R&S®ZVAB-K30 noise figure measurement option simplifies noise figure measurement, a key parameter for receiver performance evaluation.