155 Results
How to bisect the result in dB with Trace Mathematics
Recall of user's own calibration kits and connectors via remote
Calibration of two channels simultaneously with remote commands
4 Port Calibration with a 2 Port automatic calibration kit possible?
Calculate the mixed-mode S-parameter from an S4P file
Is there a way to query the data of all traces at once?
TRL calibration - middle of line or end of line
Most accurate way to measure the length of a cable with a VNA
Reading the magnitude (dB) and phase (degrees) values directly
What is the function of "Resolve pool link" in the calibration manager?
Cannot use internal display and external monitor together at the same time.
Loading an S-parameter file from a PC into a memory trace
Which settings should I use for the Transform Time Domain mode?
VNA - do I really need a sliding match for calibration?
How can I change the display resolution when I use an external monitor?
Changing the update display rate of a sweep with many sweep points.
Calibrating a vector network analyzer (VNA) with different connectors on each port
Converting the real and imaginary numbers to magnitude in dB and phase in degrees.
R&S®ZVAX-TRM User Manual
R&S®ZVAX-TRM Instrument Security Manual
What is the correct pin layout of the DC inputs on the network analyzer's rear panel?
Sending a remote Control Command internally
I have set my VNA to single sweep mode and switched on averaging with a factor of 10. But when I restart the single sweep, it stops after 1 sweep and the averaging is not done.
Rohde & Schwarz Getting Started for the R&S ZCxxx frequency converters
I query the values of a trace using scpi commands. But I get the y-values only. Is there a possibility to get the y-values also (frequency)?
I trigger this single sweep with the RSZVB_Send_Trigger_and_Wait_for_OPC driver, but this driver does not wait for the complete 10 sweeps. If I don't use averaging, this program is works.
How can I switch from remote to local state via remote control?
TDR, TDT, ZVA vector network analyzer This video series demonstrates the calibration of a four-port network analyzer and the measurement of rise time, impedance vs. distance and skew on a board with differential lines
How do I calculate these frequency points when I have a logarithmic sweep and know the center frequency, the span and the number of sweep points?
I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.