232 Results
CMW500_Overview
09-Jul-2024
EMITE and Rohde & Schwarz join forces to support OTA measurements on Wi-Fi 7 and 5G RedCapEMITE and Rohde & Schwarz continue their collaboration to enhance EMITE’s Over-the-Air (OTA) measurement solutions by fully integrating the latest test capabilities of the R&S CMX500 multi-technology, multi-channel one-box signaling tester.
Cell search and cell selection in UMTS LTE
17-Sep-2009 | AN-No. 1MA150
1MA210 - Testing LTE Release 9 Features. This Application Note describes the T&M methods for LTE Release 9 features using Rohde & Schwarz instruments.
26-Apr-2013 | AN-No. 1MA210
DTMF analysis on CMW500 and CMW290
The Rohde & Schwarz Bluetooth RF test solution with the R&S CMW and R&S CMWrun is closely aligned to the Bluetooth RF Test Suite. This document describes common setups for these tests and the required configurations.
04-May-2015 | AN-No. 1MA261
Is it possible to set up an IP peer to peer test using CMW500 between a corporate network and one EUT attached to an LTE cell?
How to configure a external trigger at CMW500, CMW290, CMW270 to synchronize with LTE signal time frames
Problems during WLAN measurement
CMW500 / CMW290: GPRS / EDGE packet data measurements failed because UE stay not in TBF (Temporary Block Flow) state.
This document provides a step-by-step guide on how to use a stand-alone R&S®CMW500 to take Rel-6 measurements on transmitter characteristics and execute performance tests according to TS 34.121 V9.7.0, clauses 5 and 10.
27-Nov-2013 | AN-No. 1CM97
26-Sep-2023
ETS-Lindgren integrates R&S CMX500 and R&S SMBV100B for 5G A-GNSS antenna performance testingETS-Lindgren integrates R&S CMX500 and R&S SMBV100B for 5G A-GNSS antenna performance testing
CMW500: No more LTE signaling function after LTE firmware update
discovery based on the R&S®CMW500 wideband radio communication tester.
This application note shows how to perform LTE terminal block error rate (BLER) and throughput tests under fading conditions with the R&S®CMW500 Protocol Tester and the R&S®AMU200A Fading Simulator.
27-Mar-2012 | AN-No. 1MA177
This document provides a step-by-step guide on how to use a stand-alone R&S®CMW500 to perform HSDPA Tests (from Rel.5 up to Rel.8 / DC-HSDPA+) measurements on transmitter characteristics and receiver characteristics in line with TS 34.121 V9.5.0.
17-Aug-2012 | AN-No. 1CM96
How can the CQI (Chanel Quality Identifier) from UE and coresponding 3GPP specified mapping to Modulation and TBS be tested?
This application note summarizes the Rohde &Schwarz test solutions for LTE-Advanced (Release 10) using Vector Signal Generators, Signal and Spectrum Analyzers and the Wideband Radio Communication Tester.
03-Sep-2014 | AN-No. 1MA166
17-Aug-2020
Continental Resources offers high volume 5G mobile device testing with Rohde & Schwarz equipmentContintental Resources offers high volume 5G mobile device testing with Rohde & Schwarz equipment. Uniting the worlds of 4G and 5G, the R&S CMX500 radio communication tester delivers a smooth upgrade path from LTE to 5G NR device testing.
09-Sep-2020
Cooper General provides 5G device service and repair with Rohde & Schwarz equipmentUtilizing the R&S CMW500 and the R&S CMX500 wideband radio communication testers, Cooper General now offers support and repair services for both 4G/LTE and 5G devices.
This application note shows how to determine the quality of a video streamed by an LTE mobile with R&S®CMW500 Radio Communication Tester and R&S®VTE Video Analyzer.
08-Sep-2014 | AN-No. 1MA253
This article describes the typical questions and considerations to be done while handling SIM Cards and using R&S instruments such as for example CMW500.
If a CMWrun test plan script has been fished the AC power of a CMW500 / CMW290 / CMW270 should be shut down automaticly.
Today’s infotainment units offer a wide range of features to truly embody the concept of the connected car.
14-Jun-2018
This application note describes how to use the LTE Frequency Division Duplex (FDD) and Time Division Duplex (TDD) measurement functionality provided by the R&S®CMW500 wideband radio communication tester to perform LTE transmitter and receiver measurements.
17-May-2013 | AN-No. 1CM94
laboratory for wireless device testing expands its test services with the Rohde & Schwarz CMX500 and CMW500 radio communication testers for 5G and LTE testing
R&S CMW Wideband Radio Communication Tester - Platform overview - Product Brochure