8397 Results
Fault messages / error codes at (blue) IMP pumps
I would like to do a Reference Calibration using ELEKTRA and Field Probe. For this I have to do Reference Calibrations at 16 positions, this does mean my Field Probe have to be set to each of the 16 predefined points. I set the probe positions manually, so an error can occur by mistake. Is it possible to repeat a measurement for a sensor position, if needed?
Impedance measurement of non 50 Ohm cable
Programming examples for oscilloscopes.
SSB Measurement Result has Changed after a Change of Span
I am existing EMC32 customer. It is possible to migrate my EMC32 templates to ELEKTRA?
I am using R&S ELEKTRA with EMI Receiver for conducted measurements with a LISN. During installation and first measurement, we had the "IFOVLD" error, what does mean results are invalid.
How can I find out that the measurement has been finished?
With the NRX how can I set a measurement result directly as a reference value for relative measurement via remote control?
How to use the User Def. Math functionality
I got a calibration kit with a sliding match standard. But there are no correction values for the NWA supplied.
Correct Step Size for a Stepped EMI Scan?
FAQ, Compatible Firmware Versions
FAQ AMS32 Signal Path Calibration, ensure that valid CAL Data are loaded on the OTA Network Analyzer
How can I set the special slot format in 5G NR measurement application for TDD?
FAQ: Activate Logins for Different Users
FAQ: Check EMC32 Expansions
DC Input?
This summary intends to give a fast overview for generation and verification of FM chirp signals using R&S Instruments and software Tools.
Remote Control Protocol using the HMC Series
Rackmount kit for Calibration Unit ZN-Z154
Extension for USB cable PC <--> NRP-Z3/4
Tracking generator leakage
Active cal kit or cal unit does not contain all standards needed for selected cal procedure.
Learn how to solve the issue in case you get the error message "Application will be closed" from EMC32 Main Startup.
I have made a phase noise measurement with the FSWP and I can see a peak at 500kHz which is a spurious.
Which Receiving Antenna is the right one?
FAQ: How can I generate and Export a Test Rreport?
Why is it helpful to do Data Reduction?
FAQ: iKey upgrade for EMC32/AMS32 version 10?