R&S®ELEKTRA Test Software - Mediacenter

Amplifier checks using R&S®ELEKTRA Test Software

In this video, we dive into amplifier linearity & stauration checks based on IEC 61000-4-3 & IEC 61000-4-6 standard using R&S®ELEKTRA in simulation mode. We will briefly walk you through the clauses mentioning about linearity & saturation checks in standards.

Conducted immunity tests based on EN61000-4-6

In this video, we dive into conducted immunity testing based on IEC 61000-4-6 standard using Elektra in simulation mode.We will briefly walk you through the CDN & BCI testing methods stated in the standards.

Create signal path

Watch this video to learn more about how to create a signal path for calibration using R&S ELEKTRA EMC test automation software.

Understanding oscilloscope drivers in ELEKTRA

Watch this video to learn more about the ELEMC-SCP option of R&S ELEKTRA EMC test automation software which enables users to integrate oscilloscopes into their test setup for EUT monitoring during Immunity testing.

Understanding customized reporting in ELEKTRA

Watch this video to learn more about the ELEMC-REP option of R&S ELEKTRA EMC test automation software which enables users to create customized test summary reports by building on predefined report templates.

Test Template

Learn in this short video about R&S®ELEKTRA EMC test automation software how to create a test template

System path calibration

Learn in this short video about R&S®ELEKTRA EMC test automation software how to calibrate the system path..

Reference Calibration Test Report

Learn in this short video about R&S®ELEKTRA EMC test automation software how to create the reference calibration and the test report.

Hardware setup

Learn in this short video about R&S®ELEKTRA EMC test automation software how to set up the test hardware.

Test Report Configuration

Learn in this short video about R&S®ELEKTRA EMC test automation software how to configure the test report.

Path switching

Learn in this short video about R&S®ELEKTRA EMC test automation software how to set up the signal path switching.

Tools setting

Learn in this short video about R&S®ELEKTRA EMC test automation software how to configure the test basics.

Attenuation Table

Learn in this short video about R&S®ELEKTRA EMC test automation software how to assign the attenuation table.

Device List

Learn in this short video about R&S®ELEKTRA EMC test automation software how to set up the devices..

EUT Test Template

Learn in this short video about R&S®ELEKTRA EMC test automation software how to create the EUT test template.

Run test

Learn in this short video about R&S®ELEKTRA EMC test automation software how to run the test.

Automotive measurements with R&S®ELEKTRA

In this webinar, we will give a general introduction to our new EMC software ELEKTRA and highlight some features with are relevant for automotive standards.

R&S®AdVISE Visual Inspection Software - Monitoring of Rotating Objects

This video shows how to use R&S®AdVISE to monitor the number of revolutions of rotating objects.

R&S®AdVISE Visual Inspection Software - Monitoring of Analog Indicators

This video shows how to use R&S®AdVISE to monitor analog indicator.

Increasing your test throughput

Intuitive user interface

Getting started quickly