Key Facts
- Full H band support from 220 GHz to 330 GHz
- Ultra-wide IF bandwidth up to 35 GHz
- Low conversion loss thanks to the integrated IF amplifier
- Superior signal quality
- High-performance external H band amplifier
Key Facts
R&S®FC330ST and R&S®FC330SR frequency converters are designed for upconversion and downconversion of intermediate frequency (IF) signals to and from the 220 GHz to 330 GHz RF frequency range. A high-performance mixer with low conversion loss ensures precise measurements, while the integrated IF amplifier enhances sensitivity and signal performance. R&S®FC330 frequency converters support a wide IF range up to 35 GHz for transmitting and receiving ultrawideband signals.
The optional R&S®FC330-Z50 external amplifier has a low noise figure and can boost transmitter output power or act as a low-noise amplifier to improve the receiver sensitivity.
Quick Links
R&S®FC330 frequency converters for upconversion and downconversion have seamless frequency coverage from 220 GHz to 330 GHz with a WR3.4 waveguide RF connector in line with the WR3 EIA standard. A set of five external bandpass filters, each with a 30 GHz passband, support flexible operations and minimize unwanted signals. These filters help selectively eliminate sideband and local oscillator signals for top performance across the entire frequency range.
R&S®FC330SR frequency downconverter
The IF frequency range of the R&S®FC330 from 1 GHz to 35 GHz enables the transmission of wideband signals and provides the user a wide range of options for the best possible IF/LO combination. Each frequency converter is characterized in the factory and comes with measurement and alignment data stored on a USB flash drive. The flexible customization allows precise system control to generate a specific RF frequency and is an ideal solution for various applications.
R&S®FC330SR block diagram
Superior signal quality is possible even at sub-THz frequencies by combining high-performance IF generation and analysis with the unique performance of R&S®FC330 frequency converters.
EVM measurement of a single-carrier signal
16QAM modulation with 4 GHz symbol rate at 286.5 GHz carrier frequency; devices: R&S®SFI100A, R&S®SMA100B, R&S®FC330ST/SR and R&S®FSW43.
The R&S®FC330-Z50 external amplifier operates within the 220 GHz to 330 GHz frequency range. The amplifier can be directly powered from the R&S®FC330 and typically has a gain of 15 dB, delivering signals with up to +8 dBm output power (measured at saturation). The low noise figure means the amplifier works in the transmit (TX) and receive (RX) directions.
R&S®FC330-Z50 external amplifier
Numéro de commande 1444.6327.02
Bandpass filter
External bandpass filter (220–250 GHz) for FC330ST and FC330SR converter
Numéro de commande 1444.6333.02
Bandpass filter
External bandpass filter (240–270 GHz) for FC330ST and FC330SR converter
Numéro de commande 1444.6340.02
Bandpass filter
External bandpass filter (260-290 GHz) for FC330ST and FC330SR converter
Numéro de commande 1444.6356.02
Bandpass filter
External bandpass filter (280-310 GHz) for FC330ST and FC330SR converter
Numéro de commande 1444.6362.02
Bandpass filter
External bandpass filter (300-330 GHz) for FC330ST and FC330SR converter
Numéro de commande 1444.6385.02
WR3.4 Waveguide-to-waveguide adapter
Waveguide section straight. Length: 400mm
Numéro de commande 1444.6379.02
AMP 220-330 GHz
External amplifier for FC330ST and FC330SR converter
Numéro de commande 1538.5875.03
Standard gain horn antenna
220 to 330 GHz, 25 dBi Connector waveguide WM-864 (WR3.4)
Numéro de commande 3593.4005.02
Waveguide Tunable Attenuator
220 GHz to 325 GHz; WR3.4 Waveguide
Numéro de commande 1175.2014.02
Torque wrench for waveguide flange screws
Produits associés