8445 Results
SCPI remote error message on the display
EMC32: Interactive data reduction, difference between "After data reduction" and "Before final measurements".
TCE900 - mixing different processor boards (IPS1 & IPS2) within one system
FAQ: Change or Upgrade from EMC32-L to EMC32-E/-C
Automatically park antenna at specific position using ELEKTRA
There is only one simple test file for DAB installed as default on the SMCV100B. But to simulate realistic DAB signals with different codec and content more test files are nessessary.
After calibration I received updated attenuation and transducer tables. How do I enter these values into the EMC32 Explorer to continue new Tests with these values?
Use the HMExplorer to create one waveform for the 600 kHz and one for the 900 kHz sine wave in the arbitrary mode. Then please combine both waveforms via the sum function to one waveform.
MXO - capacity of the internal hard disc
How to configure a external trigger at CMW500, CMW290, CMW270 to synchronize with LTE signal time frames
Differential data export
Remotely reading the Tx Power shown in the Spectrum Emission Mask measurement
Does ELEKTRA software have possibility to use the Open TEM cell for Radiated Emission?
HMC8012 - Display current and voltage measurement at the same time
Marker Disappears when IEEE is used
EMC32 measurements with more than 1000000 points
Short description:Expiration date for a ROMES dongle
Programming Examples HMC8015.
Can I measure group delay of an Audio ADC or DAC with my UPP / UPV?
Hard disk is not detected
Meaning of 0dBFS and 0dBr
FAQ, Key Code for all AMIQKxx Options
4 Port Calibration with a 2 Port automatic calibration kit possible?
UNCAL and UNDERL
FAQ; Every time when I start my EMC32, a strange error appears: "ikey for AMS32 could not be found". What to do ?
I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.
When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?
HM8118 to use external BIAS
The signal generator come in different frequency ranges. Using a program is there a way to tell the frequency range of the SMB100A for example?
FPC1000 and FPC1500: "Auto Power Up on AC" does not work correct